PLA tested so far – 1.75mm

# eSun lite Dryer

• Filament Dryer / Dehydrator
  • Comment sécher votre filament (PLA, ABS, nylon)

Time - Unit is in Hour Temperature

• 1 - PLA/PLA+ - 40°
• 2 - ABS/ABS+ / PETG - 50°

• 3 - PVA / Nylon / PC - 55°

• Faites votre propre Dual PLA

# Tech Palette

like USSA design

# Alt Palette

# Misc Palette

# Provider/Vendor

• 3djake.fr - TBD
  • PLA Economy Light Gray - TBD
  • PolyTerra PLA Arctic Teal - imprime bien mais TVOC important 1.2 mg/m³ a l’ouverture (yellow air state) - to recheck
    • excellent printing 210°C 80 mm/s / Bed at 40°C
    • very bad stickyness => + lack + height tuning
  • PolyTerra PLA Charcoal Black - TBD
  • PolyTerra PLA Fossil Grey - good printing 205°C/40°C (warp on higher bed temp) - clean glass (alcohol whipe) - 120 mm/s
    • issue with default ender 3 extruder (underextrusion issue)
  • PLA Extrafill Vertigo Galaxy - TBD
• 3DFil - TBD

# PLA

# ICE

• white (0.75kg) - easy to print - thick
  • 205°
• Groovy Gold (0.75kg) - easy to print, nice bronze/brass finish
  • 205°C/55°C - clean glass - work perfectly
• Obstinate Orange (0.75kg) - nice color
  • 200..215° / bed 60° => WAIT FOR BED TEMP + lack ortherwise does not stick well to glass

# Sunlu / thingiverse

• PLA+ White - 210° / 60°

# Heliox used

• Noulei Filament
• cuivre
• Eryone
• Ice

# Verbatim

• Silver (1kg) - very thin/precise print - 205°
• White (1kg) - easy to print - thick - 205°

# Amazon

• violet (1kg) - print at 220°, otherwise result is brittle, with loose adherence

# dagoma chromatic / delivery service bad

• red (rouge pompier) (250g)
• black (noir brillant) (250g

# PETG

• ERYONE trans blue
  • head=250/bed=80..85/fan=40%/ini layer=0.1 speed 30mm/s * 80%
  • How to create transparent 3D prints!
  • Transparent FDM 3D Prints are Clearly Stronger! / cnckitchen - How To Print Glass

# TPU?

# Dev mode

• Fiddle for this page mostly written by ChatGPT