[extruder]
# orbiter motor LDO-36STH20-1004AHG(XH)
rotation_distance: 4.637
microsteps: 16
full_steps_per_rotation:   200
max_extrude_only_distance: 500
max_extrude_only_velocity: 120 # <- for orbiter motor LDO-36STH20-1004AHG(XH)
max_extrude_only_accel:    800 # <- for orbiter motor LDO-36STH20-1004AHG(XH)
pressure_advance: 0.1				# to be calibrated
pressure_advance_smooth_time: 0.02  # to be calibrated

[tmc2209 extruder]
## orbiter motor LDO-36STH20-1004AHG(XH)
run_current:    0.850 # RMS <- for orbiter motor LDO-36STH20-1004AHG(XH)
hold_current:   0.1
sense_resistor: 0.11
stealthchop_threshold: 0

[firmware_retraction]
retract_length: 1.2
#   The length of filament (in mm) to retract when G10 is activated,
#   and to unretract when G11 is activated (but see
#   unretract_extra_length below). The default is 0 mm.
retract_speed: 60
#   The speed of retraction, in mm/s. The default is 20 mm/s.
unretract_extra_length: 0
#   The length (in mm) of *additional* filament to add when
#   unretracting.
unretract_speed: 10
#   The speed of unretraction, in mm/s. The default is 10 mm/s.